Remember, not all collars are the same, and instructions may vary based on your pattern.Resources 3D Written by Ben Traje Disclosure: This post may contain affiliate links. Turn your collar and stand right side out and press the round sides, working the seam to the edge to get a crisp finish. There’s no need for notches, and the seam turns right side out beautifully. Trim the edges of the now-attached collar stand, leaving about 1/8″, as shown above. Trim the Seam Allowances on the Collar Stand Pin in place, then stitch from corner to corner using a 3/8″ seam allowance. Sandwich the collar between the two collar stand pieces, wrong sides facing out and notches matching. Take the collar stand piece that doesn’t have interfacing (as shown in the bottom portion of the image), and press up the seam allowance on the curved edge. Stitch the collar to the interfaced stand. Line up the collar to the interfaced collar stand piece using the dots and notches as guides (as shown in the top portion of the image above).
Roll the seam edge ever so slightly toward the underneath, as it offsets the bottom edge just a bit. Take your time so you don’t poke a hole in the fabric you can tease the last bit of the corner out with a pin or needle if necessary. With a point turner (or another blunt tool), gently push the corner to create the point. (Be careful when you do this - you don’t want to trim through your stitching.) Regardless, the goal is to have the seam allowances “kiss” in the middle.
Depending on the angle of your collar point, you may have to trim more than a diagonal. Trim and TurnĬarefully trim away the point of the collar, as shown above. Use a shorter stitch near the point for extra security. Doing this before turning and pressing will give you a crisper edge.
#Simple vest sewing pattern clo3d free pro
Pro Tip: If your collar pattern has 5/8″ seams (instead of smaller 3/8″ seams), it’s a good idea to trim them down after stitching to reduce bulk. Sew the seam on the long outer edge, as shown in the image above. With the markings transferred, move the pattern pieces out of the way and place the collar pieces right sides together. Before removing the pattern pieces, transfer the pattern markings - on the collar stand, you may see notches for matching, and dots or triangles to mark the shoulder point where the collar attaches to the shirt. Once your interfacing is done, pin and cut your fabrics using the pattern pieces.
Do this before you pin and cut out your pattern pieces - make sure to test-run your interfacing on scraps to help you decide what works best with your particular fabric. You’ll need two of each piece, so the fabric will be folded to double.Īttach fusible interfacings to one of each piece to give them structure and body. Most classic shirt collars are made up of two pattern pieces: the collar (the piece shown at the bottom in the image above) and the collar stand (the curved piece at the top). Add Fusible Interfacings to Collar Pieces With this quickie tutorial - and knowing just how much fabric to shave off - you’ll be turning out shirt collars that are so ahh-mazing, you’ll have major bragging rights when you tell people you did it yourself. But does it always have that crisp, snappy look? If not, you may be missing out on a major secret: trimming. Sure, you can sew a shirt collar no problem.